Starting at €0.00
- It does not create thermal bridge
- Quick installation with a simple electrical screwdriver
- Suitable for standard screws
- Covering with white, black or dark brown washer (page 125)
For fastening of light loads on thermal insulation systems, directly on the coating. Fastening by screwing with bit Torx 40 or special hex insert. Pre-molded hole for chipboard screws, hook screws and eyelet screws ø 4,5 mm. For fastening of light loads: mailboxes, house numbers, signs and small lighting systems.
- Follow carefully the instructions.
- To prevent water seepage under the head of the anchor and the insulating material, it is recommended to seal the edge with silicone or acrylic sealant at the end of the installation or before laying the washer.
- To improve the load, use the glue GofixTM (NAF41000). Drill a pre hole with a bit ø 10 mm of 1 cm longer than the length of the anchor. Fill the hole with glue up to half and follow the installation instructions. A'er installation, remove the excess glue.
- It does not create thermal bridge
- Quick installation with a simple electrical screwdriver
- Suitable for standard screws
- Covering with white, black or dark brown washer (page 125)
For fastening of light loads on thermal insulation systems, directly on the coating. Fastening by screwing with bit Torx 40 or special hex insert. Pre-molded hole for chipboard screws, hook screws and eyelet screws ø 4,5 mm. For fastening of light loads: mailboxes, house numbers, signs and small lighting systems.
- Follow carefully the instructions.
- To prevent water seepage under the head of the anchor and the insulating material, it is recommended to seal the edge with silicone or acrylic sealant at the end of the installation or before laying the washer.
- To improve the load, use the glue GofixTM (NAF41000). Drill a pre hole with a bit ø 10 mm of 1 cm longer than the length of the anchor. Fill the hole with glue up to half and follow the installation instructions. A'er installation, remove the excess glue.