Starting at €0.00
- It does not create thermal bridge
- Quick installation with a simple hammer and does not require a pre-drilled hole
- Suitable for standard screws
- Covering with white, black or dark brown washer (page 125)
- Exclusive patented design: resistant to tensile stress, rotation-proof during screw’s tightening. For fastening light loads on thermal insulation systems, directly on the coating. Fastening with hammer. Pre-molded hole for chipboard screws, screws and eyelet ø 4,5 mm. For fastening of light loads: mailboxes, house numbers, signs and small lighting systems.
- Follow carefully the instructions.
- To prevent water seepage under the head of the anchor and the insulating material, it is recommended to seal the edge with silicone or acrylic sealant at the end of the installation or before laying the washer.
- To improve thel oad, use the glue GofixTM (NAF41000). Drill a pre hole with a bit ø 10 mm of 1 cm longer than the length of the anchor. Fill the hole with glue up to half and follow the installation instructions. After installation, remove the excess glue. PATENTED
- It does not create thermal bridge
- Quick installation with a simple hammer and does not require a pre-drilled hole
- Suitable for standard screws
- Covering with white, black or dark brown washer (page 125)
- Exclusive patented design: resistant to tensile stress, rotation-proof during screw’s tightening. For fastening light loads on thermal insulation systems, directly on the coating. Fastening with hammer. Pre-molded hole for chipboard screws, screws and eyelet ø 4,5 mm. For fastening of light loads: mailboxes, house numbers, signs and small lighting systems.
- Follow carefully the instructions.
- To prevent water seepage under the head of the anchor and the insulating material, it is recommended to seal the edge with silicone or acrylic sealant at the end of the installation or before laying the washer.
- To improve thel oad, use the glue GofixTM (NAF41000). Drill a pre hole with a bit ø 10 mm of 1 cm longer than the length of the anchor. Fill the hole with glue up to half and follow the installation instructions. After installation, remove the excess glue. PATENTED